Altman CHALICE Manual de Instruções descarregar pdf (Página 5)

Lighting

BRINGING IMAGINATION TO LIGHT

Lighting

BRINGING IMAGINATION TO LIGHT

ManualINSTALLATION & OPERATION

Chalice Series

57 Alexander St., Yonkers, NY 10701 Tel: 914-476-7987 Visit our website at www.altmanlighting.com

SETUP AND INSTALLATION

Unpacking

Remove the CDR50 & CDR100 Recessed Chalice lighting  xture from its shipping box. Set the unit down on

a  at surface before proceeding. Remove the trim ring and lens from the  xture by squeezing the two ten-

sion springs on the trim ring and set aside.

Lamping and Re-lamping

The CDR50 & CDR100 Recessed Chalice lighting  xture is provided with an integral 50W and 100W LED light

engine respectively. Under normal operating conditions, the LED light engine should have a rated life ex-

pectancy of over 50,000 hours. There are no user serviceable parts inside. The entire LED assembly will need

to be changed.

Mounting the  xture

The CDR50 & CDR100 are designed for ceiling mount only and away from insulation. Install two mounting

brackets onto either side of the  xture, but removing the ¼-20 screw and mounting the two brackets to the

hole in the  xture side. Cut out an appropriate size 6” diameter hole for the CDR50 or an 8” diameter hole

for the CDR100. Install the  xture from the top of the ceiling onto the hole cutout making sure to align the

center of the LED light engine to the center of the hole. Hold the main  xture body in place and secure each

end of the two mounting brackets to adjacent beams. Secure the four ends of the brackets in place to a

beam using either drywall or wood screws. Note: Use the beams to support the  xture, not the surface of the

ceiling.

Connecting power and/or data to the  xture

Wiring should be done by a quali ed electrician. AC high power and DC low voltage DMX512 data can be

brought to the  xture through any of the many knock-outs provided. Make sure the  xture is wired to a

properly grounded circuit breaker. For DMX512, connect COM, Data+ and Data- as marked inside the  xture.

Focusing the  xture

Install the trim ring with the lens back onto the  xture by squeezing the two torsion springs into the two

slots provided on the  xture from the bottom. To change lenses in the CDR50, pull the two tabs holding the

lens down up and away with a needle nose pliers. Put them back in place when the new lens is installed. For

the CDR100, simply slide the lens retaining pins, clips, or tabs out of the way and back in place onto the new

lens.

Cleaning the  xture

Routine cleaning of the CDR50 & CDR100 Recessed Chalice lighting  xture will provide years of prolonged

use. Use compressed air to blow o any dust and dirt from the lens, re ector, electronics and heat sink. For

the lens, use a soft lint-free cloth dampened with water to clean the lens of dust and dirt. Dry o completely

with compressed air or a dry lint-free cloth.

ETL FILE LISTING

The CDR50 & CDR100 Recessed Chalice lighting  xture is ETL and c-ETL listed under Altman File 9700680 for

UL1598 and UL8750 for Luminaires.

1 2 3 4 5 6 7 8 9 10 ... 25 26

Comentários a estes Manuais

Sem comentários

Altman CHALICE Manual de Instruções Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Holofotes Altman CHALICE